BOBBIN CASE TENSION GAUGE LRG CAP TM-3
Towa Griswold BTG3 400TM3 M Size Bobbin Case Thread Tension Gauge 0-400g Pull For Industrial Sewing Embroidery Quilt Machines Not Drop-In Bobbin Cases. The gauge allows embroiderers to consistently set accurate embroidery bobbin case tension on style M jumbo embroidery bobbin cases. Eliminates guesswork. In just a few seconds you can verify your bobbin tension is where it should be to achieve optimum results. It's simple to use and comes with complete instructions. No setup is required. It's ready to use right out of the box.
BTG-3: Used with the following bobbin cases: 18045, P413830, H-15, B1837-201-0A0 & 147790-0-01
Instructions for Use:
Remove the bobbin case from your machine. Be sure the bobbin thread is out of the pigtail and place your bobbin case with the bobbin in it into the gauge slot. Snap the bobbin case in place.
Wrap the bobbin thread around the two pulley wheels and around the plastic hook end on the gauge.
Steadily pull the thread and note the reading on the gauge. This represents tension readings in grams. Correct bobbin tensions should be 180 to 220 grams (up to 250 grams when embroidering caps).
Please Note: If your gauge is shown in units of 10's, the correct bobbin tensions should be 18 to 22 grams (up to 25 grams when embroidering caps.)
Adjust the bobbin case spring tension screw as needed to get the desired reading.
Note: The gauge needle should provide a steady reading. If you experience a bouncing, erratic reading it can be due to a dirty or defective bobbin case.
Tip: Slide a business card back and forth under the bobbin tension spring to clear any dirt.
Once you have adjusted your thread tensions, it's always a good idea to run tests.
First, run a fill stitch test pattern.
If you experience any top stitch looping, slowly tighten the main upper tension knob until this looping goes away (looping can also occur if your bobbin tension is too tight).
Proper tensions for satin stitches should reveal 1/3 bobbin and 2/3 top thread color on the underside of the embroidery.
Note: Too much bobbin showing on the underside and/or showing on the topside usually means either the bobbin tension is too loose or the top thread tension is too tight.
Recently Viewed Items
Stay in the loop with industrial cutting & sewing equipment